Siemens EH.75M.11. Especificaciones descargar pdf (Pagina 144)

T400 Controller Facilities Manual

667/EB/20200/000 Page 15-4 Issue 9

15.7 PORT ALLOCATION

Port numbers are allocated as per the following table:

Board Type Port No Port Type Connector name

CPU 0 INPUT PLE

CPU 1 INPUT PLE

CPU 11* OUTPUT PLC

Expansion I/O (a) INPUT PLB

Expansion I/O (b) INPUT PLC

Expansion I/O (c) OUTPUT PLE

Expansion I/O (d) OUTPUT PLD

SDE/SA 6 INPUT PLB

SDE/SA 7 INPUT PLB

SDE/SA 8 INPUT PLC

SDE/SA 9 INPUT PLC

Where a, b, c and d are:

Expansion

I/O Board 0

Expansion

I/O Board 1

Expansion

I/O Board 2

a2 6 10n/a

b 3 7 11* or n/a

c4 8 n/a10

d 5 9 n/a 11*

The Expansion I/O Board no. is indicated on the rotary switch on the front of each

board.

* Port 11 can be defined as either 4 bits of output (on the main CPU board) or 8

bits of input or output (using Expansion I/O board 2).

The following figures will assist when allocating the ports:

Figure 15.1 - BLOCK DIAGRAM OF MAIN PROCESSOR BOARD

Figure 15.2 - PCB POSITIONS AND LAYOUT OF PHASE DRIVER

RIBBON CABLES

Figure 15.3 - REAR VIEW OF PCB I/O CONNECTIONS (T400 LARGE

SHOWN)

Figure 15.4 - TERMINAL BLOCKS IN SMALL CONTROLLER

Figure 15.5 - TERMINAL BLOCKS IN LARGE CONTROLLER

Figure 15.6 - TERMINAL BLOCKS IN LARGE CONTROLLER (HONG

KONG)

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 307 308

Sin comentarios

Siemens EH.75M.11. Especificaciones Pagina 144