Siemens IC60 Manual de usuario descargar pdf (Pagina 94)

Areas

Building Technologies

Fire Safety & Security Products

Area Stay Exit Beeps

P59E 1-2E

(1 = Area A; 2 = Area B)

When an Area is armed in Stay Mode it is useful to have the exit delay beeps

occurring at the keypad to warn the User to exit the premises without delay. If the

option is on at this address, that keypad will beep out the exit delay. This option

may be turned off for Stay Mode to make the keypad silent when arming at night

time. The exit beeps occur at one second intervals until the last 5 seconds at which

time they change to ½ second intervals to act as a warning that the delay is about

to expire. When arming Stay Mode the exit and entry delays can be cancelled by

pressing the

button following arming of Stay Mode. The next time Stay Mode is

armed, if the

button is not pressed, all programmed exit and entry delays will

apply.

Option 1 = Keypad 1; Option 2 = Keypad 2 etc.

17.4 Exit delay time settings / area

Area Arm Exit Time

P60E 1-2E 0-255E

(1=Area A; 2 = Area B) (Value 0-255 Sec.)

Each Area can have its own exit delay time. The delay can be programmed from 1-

255 seconds in one second increments. If the exit delay is set to 0 the panel will be

instantly armed.

Area Stay Exit Time

P61E 1-2E 0-255E

(1=Area A; 2=Area B) (Value 0-255 Sec.)

Each Stay Mode Area can have their own exit delay time. The delay can be

programmed from 1-255 seconds in one second increments. If the exit delay is set

to 0 the panel will be instantly armed.

17.5 Monitoring account code number

Area Account Code

P62E 1-2E 0000-FFFFE

(1 = Area A; 2 = Area B) (Value 0000-FFFF)

When the dialer is reporting to a monitoring station there must be a unique account

code programmed to identify the panel. There is an account code for each area.

The account code is 4 digits. Each digit can be a number from 0-9 as well as the

special characters B, C, D, E & F. The chart below shows how the special

characters are entered.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 94