Siemens IC60 Manual de usuario descargar pdf (Pagina 54)

LCD keypad

Building Technologies

Fire Safety & Security Products

8.6.3 Historical memory event

Following the Current System Alarms the panel will display the historical memory

events. The panel stores the most recent events, (up to 255), including all alarm

events, all system events such as mains failure etc as well as arm/disarm by User

& Area. The memory events are displayed via the LCD keypad with the most

recent event shown first and subsequent events following in descending order from

newest to oldest.

During the Historical Memory Event display mode the LCD display will show the

type of event on the top line e.g. Area A armed by User 1 and the actual time

and date that the event occurred on the bottom line.

To view events simply press the

button. The keypad will beep and the display is

advanced to the next event every time the

button is pressed.

If you wish to go back and look at an earlier event you can use the

button to go

back to an earlier event. Each time the

is pressed the memory will go back one

event.

To cancel the memory displays just press

If the

button is not pressed, the keypad will automatically exit memory display

mode after approximately 20 seconds.

When there is a new event in memory the words System Check will be shown on

the LCD.

The System Check display will be reset- change to System OK once the event

has been viewed.

8.6.4 LCD quick view mode

If any zones are unsealed when disarmed the LCD keypad will scroll through each

unsealed zone displaying the 16 character name for each zone. If a number of

zones are unsealed simultaneously it can take sometime for the display to show all

of the unsealed zones.

By pressing the

button when zones are unsealed the keypad will enter the

Quick-view Mode. When in Quick-view Mode, each unsealed zone is displayed as

a single two digit number e.g. 01 05 10. Up to 5 unsealed zones maybe

displayed at one time. If more than 5 zones are unsealed at the time the display

will scroll to the next bank of 5 zones so the user can see quickly which zones are

unsealed. To exit Quick-view Mode you simply press the

button again or the

keypad will time out automatically in approximately 30 seconds.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 171 172

Comentarios a estos manuales

Sin comentarios

Siemens IC60 Manual de usuario Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens IC60