Siemens IC60 Manual de usuario descargar pdf (Pagina 42)

Extension modules for Sintony 60 control panel

Building Technologies

Fire Safety & Security Products

7 Extension modules for Sintony 60 control panel

Various extension units could be connected to the Sintony 60 to expand the

functionality.

7.1 Output module 12V/1A IRO6-04 (Output 5-8)

With this extension PCB the Sintony 60 could be extended with additional 4 Relays

to a maximum of 8 Outputs. Each relay could switch a max. power of 12V/1A.

The connection to the Sintony 60 control panel is realized over the system bus.

Therefore it is an intelligent member of the Bus and could be programmed over the

control panel. It could be installed either directly in the control panel (Sintony 60M-

modular only) or external. The terminals are connected to corresponding terminals

on the remote devices marked POS, NEG, CLOCK, & DATA.

Max. 2 boards can be connected (max. 8 outputs total).

7.2 Zone expander module IZE6-04

This Module makes zone doubling and EOL end of line resistor connections very

easy. It contains all necessary resistors to expand the control panel and offers

clearly marked terminal blocks for 2 line in and 4 lines out. This module can be

used instead of the in the delivering included separate resistors and to save

installation costs if placed outside the control unit. (less cabling needed) Maximum

4 expander modules could be used per control panel.

7.3 Radio receiver IRFW6

The IC60 panel can have wireless capability via the IRFW6 receiver module

(Sintony 60 modular optional, Sintony 60 compact already build in).

The receiver will add wireless capability to your system in the form of wireless

Alarm sensors and wireless Remote controls. The IRFW6 connects to the system

bus port as the keypads and the other intelligent bus participants of the system.

The IRFW6 is available in 2 frequencies, 868MHz and 915MHz. Up to 2 IRFW6

can be connected to the panel to increase the coverage range if desired. The red

LED fitted to the IRFW6 receiver will flash at 1 second intervals when in Learn

Mode (see chapter

12.1: Learn a remote control / radio pendant; Pendant learn;

P18E &

20.12: Learn a wireless detector / code to the system; Zone Learn Radio;

P164E). The LED will also turn on when it is receiving an actual radio transmission

(on steady). It could be installed either directly in the control panel (Sintony 60M-

modular only) or external. The terminals are connected to corresponding terminals

on the remote devices marked POS, NEG, CLOCK, & DATA. In the Sintony 60

compact is the radio receiver normally already integrated (could vary in different

countries), but a second receiver IRFW6 can also be connected externally through

the bus to increase the coverage range if desired.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 42