Siemens IC60 Manual de usuario descargar pdf (Pagina 17)

Programming to EN 50131

Building Technologies

Fire Safety & Security Products

P122E Option 3:

Not an Exit Delay Zone

refer to chapter

20.2: Zone type options- basic information

Option 3:

Not an Exit Delay Zone: if this option is turned on the zone will not have any exit

delay and will cause an instant alarm if triggered during the exit delay time. Also

you MUST ensure that if this option is turned on for a zone, that same zone should

not have any entry delay (P144E) programmed. If the zone does have an entry

delay the zone can activate during the exit time thereby starting an entry delay on

the same zone which means the user might not be aware of the pending alarm and

leave the premises. If the zone has no entry delay and the zone is triggered during

the exit time the alarm will then be instant alerting the user that they deviated off

the exit route.

According EN 50131-3 the user must have an option to define the zones in

the exit route.

P200E Option 13:

Installer code

refer to chapter

27.7: Installer code

Installer Code: if option 2 in P25E 10E (Installer Direct Access) is off, the only way

for installer to access is through client mode. The installer must enter first to client

mode and go to P200E 13E and enter the code there. The code will not be

presented on the LCD (confidential), he will be blanked out.

According EN 50131-3 the system shouldn't present the Installer code while

typing it through the client mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 17