Siemens IC60 Manual de usuario descargar pdf (Pagina 73)

Learn, find and delete remote controls and tags

Building Technologies

Fire Safety & Security Products

12.3 Find a remote control / radio pendant location

Only Users 21-100 can be Radio Pendant.

Find Pendant

P20E 21-100E

If you have a Radio Pendant loaded into the panel but are unsure which location

(User #), pressing P20E while in Installer program Mode will start Find Mode. The

keypad will start to beep to indicate that Find Mode has been started and the LED

on the Receiver will flash. Now press the Radio Pendant button that you wish to

find. If the Radio Pendant is in memory the keypad will display the number (1-16

indicates a zone, and 21-100 indicates a user). The keypad will stop beeping and

the LED on the Receiver will stop flashing.

12.4 Learn an access tag / card code to the system

Tag Learn

P21E 1-100E

An access Tag/Card must be enrolled into the panel before it can be used. The

panel can have up to 100 proximity tags (key-ring style card), or proximity cards

loaded into the system. The tags or cards are stored separately to the User Codes

but they follow the options of Users 1-100 programmed at locations P2E, P3E,

P4E, P9E, P10E, P12E, P13E & P14E. For example if user 11 is assigned to area

A (P3E Option 1), and can arm/disarm the alarm (P4E Options 1 & 3), then access

Tag/Card number 11 will arm/disarm area A also.

To learn an access Tag/Card you must first have a compatible proximity reader

connected to the panel keypad bus. With the reader connected and the panel in

program mode, entering P21E then the access Tag/Card number you wish to

enroll, e.g. 11E for Tag/Card number 11, the keypad will start to beep to indicate

that learn mode has been started. Now present the access Tag/Card to the reader.

Once the Tag/Card number has been received by the panel and saved, the keypad

will stop beeping to indicate learn mode has stopped.

When learning a new access Tag/Card the panel checks all possible locations

before saving the new code to ensure that the code has not already been loaded. If

the Tag or Card already exists, the panel will not terminate learn mode but instead

it will continue looking for a new Tag or Card to be presented. This allows a new

Tag or Card to be learnt while existing Tags or Cards may be in use on the system.

After learning the Tag or Card, before it will work you MUST select the appropriate

option at location P2E (options 2, 3 or 4 must be selected for the tag to work).

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 73