Siemens IC60 Manual de usuario descargar pdf (Pagina 166)

Support

166

Building Technologies

Fire Safety & Security Products

31 Support

31.1 FAQ frequently asked questions

What can the installer do when the user forgets its user code?

Answer: when the user forget his user code there are several things that the

installer can do:

A - If the system is disarmed and direct access to installer mode is enabled then

get into installer mode and check the code

B - If the system is armed you can use the upload/download software and then

disarm, get the code and if needed change it.

C- If the system is armed there is a second possibility, in the default configuration

the key-switch is enabled, so you can simulate a key-switch by adding a 4.7K ohm

resistor to the tamper input. This way you can disarm the system

D - Another way to reach installer mode is the “back door “option. If the installer

enabled the back door option then you have to open the tamper, power up the

system with a tamper opened and press

Prog

than and the system enters installer

mode

What is wrong when an installer connects to the control panel with the

upload/download software and there communication (there is a connection,

the Rx TX led's are Blinking) but you can upload or download or enter real

time monitor?

Answer: this can happen if there is a security code defined in the system the code

isn’t typed when you are connected, all you have to do is type the code.

If the installers replace the receiver board is there a need to learn the

detectors again?

Answer: No, when you learn the detectors the radio code is saved in the control

panel memory, and not in the receiver

Is it possible to connect a second receiver to the control panel in case of bad

reception areas, and if yes wont there be a double alarm (one from each

receiver)?

Answer: There is no problem to connect several receiver boards, for the control

panel it is the same if it has 1 or 2 or 5 receivers on the bus. There will not be a

multiple alarm from several receivers because there is a short lockout for the

message from the receiver and the panel will only relate to the first one.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 166