Siemens IC60 Manual de usuario descargar pdf (Pagina 128)

Dialer

128

Building Technologies

Fire Safety & Security Products

22.7 Forced test call code options

DTMF Call Code

P175E 15E 0-9999E

(Value 1-4 digit code 0-9999)

If a user wishes to remotely force a test call from the panel to a monitoring

company using the Contact ID test message, you can dial the panel and when it

answers enter the code programmed at this location on the telephone.

If a voice board is fitted you can assign a voice message (see chapter

22.8:

Manual test call initiated voice message number; P176E 11E) to indicate that the

function was started. If no voice board is fitted but there is a DTMF IC fitted to the

panel you will get 3 short beeps after the code is entered to indicate the function

was started. Once you hang-up the phone the panel will then make a call to the

monitoring company and send a manual test call message. If no code is

programmed at this location (e.g. 0) the function will be disabled. The code can be

a 1-4 digit number as required.

It is also possible to force a locally generated test call from the panel keypad by

pressing and holding the

button then within two seconds of pressing control.

This will force a test call to the monitoring company.

If using this remote test code and any of the other remote DTMF codes at locations (P63E,

P175E 12E, P175E 13E & P175E 14E) you should make this code a 4 digit code to ensure the panel

knows what function is being operated. If no other DTMF remote functions are being used this code

can be a single digit.

22.8 Manual test call initiated voice message number

Remote Test Message

P176E 11E

You can trigger the panel by manual (

+ ) to send test call to the central station

and receive immediately a call (P176E 11E) with your voice recorded indicate that

manual test as been done.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 171 172

Sin comentarios

Siemens IC60 Manual de usuario Pagina 128