
SIA Codes reporting format SIA III
139
Building Technologies
Fire Safety & Security Products
25 SIA Codes reporting format SIA III
Most of the SIA Event Codes are fixed within the panel but some locations such as
zones at P196E (1-16E) and Panic/Fire/Medical at P197E (1-3E) can have a user
defined report code from the table below. To activate this transmission format refer
to chapter
23.2: Reporting formats (P182E1E10E).
25.1 SIA reporting codes - standard default setting
To following codes are the defaults SIA reporting codes.
Event Type
SIA
Alarm Code
SIA Restore
Code
Armed, 24 hour & Near Zone Alarms (programmable P196E) BA BH
Zone Verified Alarm Activated BV BH
Zone Bypassed BB BU
Zone Tamper Activated BT BJ
Sensor-Watch Fail NA NS
Radio Zone Supervise Fail BZ BR
Pendant or Radio Zone Low Battery XT XR
Keypad or Pendant Panic Alarm (programmable P197E 1E) PA PH
Keypad Fire Alarm (programmable P197E 2E) FA FH
Medical Alarm (programmable P197E 3E) MA MH
Duress Alarm HA HH
Panel or Keypad Tamper Switch Activated TA TR
Panel Battery Low YT YR
Panel AC Fail AT AR
Output Tamper Alarm (OP 1 & 2 only) YA YH
12V Output Failure YP YQ
Phone Line Fail LT LR
Automatic Test Message RP
Manual Test Call RX
Area Delinquency Alarm CD CT
Excessive Code Attempts Alarm JA
Armed by User, Pendant, ARM button, DTMF or PC CL OP
Area Armed by Key-Switch CS OS
Area Armed by Time Zone CA OA
Stay Mode Armed by User, Pendant, KS, STAY Button CG OG
Fail to Arm by Time-Zone CI
Program Mode Entry/Exit LB LX
Checksum Fail (Corrupt EEPROM Data) YF
Tab. 8 Report codes alarm events used with SIA protocol transmission
Comentarios a estos manuales