Siemens SPCK421 Especificaciones descargar pdf (Pagina 90)

Engineer programming via the keypad

X-BUS

Siemens AB

A6V10276959

Security Products

18.11.2011

For readers with a green and a red LED.

For SIEMENS readers with a yellow LED (AR618X).

Profile 3 is used with HID readers that send a PIN to the panel as a card reading

with a predefined site code (0 )

Profile 4 is used with HID readers that send a PIN to the panel as a card reading

with a predefined site code (255 ).

See also

 Door Controller [➙ 39]

14.5.4 ADRESSING MODE

X-BUS addressing can be configured in one of the 2 following ways:

Automatic addressing

Automatic addressing can be done with a combination of rotary switch and without

rotary switch expanders. With automatic addressing, the controller over-rides rotary

switches and automatically assigns expanders and keypads in the system unique

IDs in sequential order

Manual addressing

Manual addressing allows manual determination of each expander/keypad ID in a

system. All devices should be installed where required and each ID set manually

using the rotary switches.

If 2 devices of a kind (e.g. expanders) are set to same ID, upon configuration,

both expanders beep and the flashing LED indicates conflict. Reset the switches

and the system rescans.

On a device, if both rotary switches are set to zero (0, 0), the full configuration

becomes an automatic addressing configuration.

To select the ADDRESS MODE:

1. Scroll to ADDRESS MODE.

2. Press SELECT.

3. Toggle for appropriate address mode: AUTOMATIC or MANUAL

4. Press SELECT to update the setting.

14.5.5 XBUS TYPE

To program the X-BUS type from the keypad:

1. Scroll to XBUS TYPE.

2. Press SELECT.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 295 296

Sin comentarios

Siemens SPCK421 Especificaciones Pagina 90