Siemens SPCK421 Especificaciones descargar pdf (Pagina 212)

Engineer programming via the browser

Configuring communications

212

Siemens AB

A6V10276959

Security Products

18.11.2011

Physically connect the PC to the controller by connecting the DB9 serial port on the

PC to the RJ45 interface on the SPC labeled RS232 using cable detailed above

Configuring the serial port on the controller:

1. Enter ENGINEER programming mode on the keypad or browser.

2. Configure Serial Port 2 with the following settings.

- Bits per second: 115200

- Data bits: 8

- Parity None: None

- Stop bits: 1

- Flow Control None: None

Connecting to the controller from the PC (running Windows XP):

1. Select Programs > Accessories > Communications > HyperTerminal

2. Enter a name for the new connection.

3. Select the serial port COM1.

4. In the Port settings, select the following:

- Bits per second: 115200

- Data bits 8: 8

- Parity None: None

- Stop bits 1: 1

- Flow Control None: None

5. Click OK to make the HyperTerminal connection.

 If the serial connection has been programmed as TERMINAL, then the

HyperTerminal window prompts the user for a Username and password.

6. Enter the following:

- Username: Engineer

- Password: 1111 (Default)

7. Enter the command “lst” to view a complete list of the commands available at

the command prompt.

 If the serial port connection type has been programmed as PRINTER, a list

of SPC system events is displayed.

8. The Terminal window displays a list of command prompts.

Serial port 2 shares a communications channel with the back-up modem. If a

back-up modem is installed, then it must be removed to enable serial

communications on this serial port. The Serial Port 2 interface is also available as

a terminal block connection (TX, RX, GND).

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 295 296

Sin comentarios

Siemens SPCK421 Especificaciones Pagina 212