Siemens SPCK421 Especificaciones descargar pdf (Pagina 285)

Appendix

Zone types

285

Siemens AB

A6V10276959

Security Products

18.11.2011

TECHNICAL

Intruder

The tech zone controls a dedicated tech zone output. When a tech zone

changes state, the tech zone output will follow. That is:

 When the tech zone opens, tech zone o/p triggers on

 When the tech zone closes, tech zone o/p goes off

If more than one tech zone has been assigned, the tech zone output will

remain on until all tech zones are closed.

MEDICAL

Hold-up

This zone type is used in conjunction with radio or hardwired medical

switches.

Activation in any mode will:

 Trigger the medical digital communicator output (unless Local

attribute is set)

 Cause the panel buzzer to sound (unless Silent attribute is set)

 Display the message Medic Alarm

KEYARM

Intruder

This zone type is normally used in conjunction with a key lock

mechanism. A Keyarm zone will SET the System / Area / Common

Areas when it is OPENED and will UNSET the System/Area/Common

Areas when it is CLOSED.

 If the zone with the keyarm zone type is assigned in an non area

system then the keyarm operation will SET/UNSET the system.

 If the zone with the keyarm zone type is assigned to an area then

the keyarm operation will SET/UNSET the area.

 If the zone with the keyarm zone type is assigned to a common area

then the keyarm operation will SET/UNSET all the areas in the

common area.

 If the ‘Open only’ attribute is set then the armed status of the System

/ Area / Common Areas will toggle on each opening of the key lock. (

i.e. Open once to SET the system, Close and Open again to

UNSET)

 If the ‘Fullset Enable’ attribute is set then zone activation will only

Fullset the system.

 If the ‘Unset Enable’ attribute is set then zone activation will only

unset the system.

Keyarming will force set the system/area and auto-inhibit any open

zones or fault conditions.

Note: Your system will not comply with EN standards if you enable this

zone type to set the system without a valid PIN being required.

SHUNT

Intruder

This zone type is only available in Commercial Mode of operation.

Though the Shunt Alarm Zone type can be set in Domestic Mode of

operation, it has no effect.

This zone type when opened inhibits all zones that have the shunt

attribute set. This operation applies for both SET and UNSET modes. As

soon as the shunt zone is closed, the zones with the shunt attribute set

will become un-inhibited again.

X-SHUNT

Intruder

This zone type is only available in Commercial Mode of operation.

A zone programmed with the x-shunt zone type inhibits the next

consecutive zone on the system whenever it is opened. This operation

applies for both SET and UNSET modes. As soon as the x-shunt zone

type is closed the next zone becomes de-inhibited again.

DETECTOR FAULT

Fault

Detector Fault zones are 24 hour zones that are applicable to a detector

device, for example, a PIR. The fault zone type triggers the Fault output.

When the system is armed, a LED on the keypad and optional internal

audible alarm indicates the fault. Only the keypad LED is activated when

Unarmed.

This zone type will report the SIA messages, BT (Burglary Trouble) and

BTS (Burglary Trouble Restore) and for CID, a sensor trouble event

(380) is produced.

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 295 296

Comentarios a estos manuales

Sin comentarios

Siemens SPCK421 Especificaciones Pagina 285

Comentarios a estos manuales

Relacionado con productos y manuales para Teclados numéricos Siemens SPCK421