Siemens SPCK421 Especificaciones descargar pdf (Pagina 241)

Engineer programming via the browser

Configuring advanced settings

241

Siemens AB

A6V10276959

Security Products

18.11.2011

Keypad valid PIN – this condition can be configured for a particular user or for

any user. With this configuration, if the configured user (or any user) enters a

valid PIN, or presents a configured PACE, it will cause an instantaneous pulse

OFF/ON/OFF.

Keyswitch – the trigger can be configured for a specific key position on the

keyswitch.

Time Trigger –the trigger is on at the specific time entered in the box provided,

in the format hh:mm.

WARNING

Your system will not comply with EN standards if you enable a trigger to set the

system without a valid PIN being required.

15.13.3 Mapping Gates

Triggers are used with Mapping Gates, which are virtual outputs defined by the

user that can be mapped to a physical output. There can be a maximum of 256

Mapping Gates.

For continuous output, when the trigger is a valid user code, both states must be

the same, either both negative or both positive.



Select Settings > Advanced > Mapping Gates.

 The following window will be displayed.

1. Enter a Description for the gate. This is important as no mapping gate number,

only the description, is displayed on the Outputs user page for turning on and

off gates.

2. Tick the Protected check box if you do not want to allow users to turn on and

off this gate, even if they have the right to do so. A protected gate does not

appear in the Outputs setting page for users.

3. Select desired Quick Key.

A quick key is a ‘#’ followed by a single digit pressed at the keypad. If a

shortcut is configured and is pressed at the keypad, the user is prompted to

turn the output on or off.

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 295 296

Sin comentarios

Siemens SPCK421 Especificaciones Pagina 241