Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 76)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-76

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10781 Channel %1 block %2 illegal orientation of involute with tool radius

compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Tool radius compensation is possible for involutes only if the compensation plane matches the invo-

lute plane.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10782 Channel %1 block %2 illegal curve type with tool radius compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: This alarm occurs, if an attempt is made to apply the tool radius compensation to a curve type for

which this function is not implemented. The only cause at present: Involute with 3D tool radius com-

pensation.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10783 Channel %1 block %2 tool radius compensation type requires orientation

transformation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: This alarm occurs, if an attempt is made to activate a tool radius compensation which must enable a

tool orientation change and the _Orientation transformation_ option is not available. This alarm can

only occur if one of the following G code is active in the G code group 22:

- CUT3DC

- CUT3DCC

- CUT3DCCD

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: - Modify part program

- Install "Orientation transformation" option

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 391 392

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Especificaciones Pagina 76

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl