Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 183)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-183

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: The vocabulary word ACP (Absolute Coordinate Positive) is only allowed for "modulo axes". It causes

approach of the programmed absolute position in the specified direction.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

In the displayed NC block, replace the vocabulary word ACP by specifying AC (Absolute Coordinate).

If the alarm display is the result of an error in the axis definition, the axis can be declared as a rotary

axis with modulo conversion by means of the axis-specific MD 30300 IS_ROT_AX and MD 30310

ROT_IS_MODULO.

Corresponding machine data:

MD 30 320 DISPLAY_IS_MODULO

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16820 Channel %1 block %2 traverse instruction ACN for axis %3 not allowed

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: The vocabulary word ACN (Absolute Coordinate Negative) is only allowed for "modulo axes". It

causes approach of the programmed absolute position in the specified direction.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

In the displayed NC block, replace the vocabulary word ACN by specifying AC (Absolute Coordinate).

If the alarm display is the result of an error in the axis definition, the axis can be declared as a rotary

axis with modulo conversion by means of the axis-specific MD 30300 IS_ROT_AX and MD 30310

ROT_IS_MODULO.

Corresponding machine data:

MD 30320 DISPLAY_IS_MODULO

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16830 Channel %1 block %2 incorrect position programmed for axis/spindle %3

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: A position outside the range of 0 - 359.999 was programmed for a modulo axis.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program a position within the range from 0 - 359.999.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16903 Channel %1 program control: action %2<ALNX> not allowed in the

current state

Parameters: %1 = channel number

%2 = action number/action name (see Section 1.5 Action List)

Definitions: The relevant action cannot be processed now. This can occur, for example, when machine data are

read in.

Reaction: Alarm display.

Remedy: Wait until the previous process is finished or abort with Reset and repeat the operation.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 391 392

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Especificaciones Pagina 183

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl