Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 362)

100

101

List of action numbers 06/2007

3-362

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

No. 116, TOOLCHANGECMDON

No. 117, TOOLCHANGECMDOFF

No. 118, SIVLIMCHANGE

No. 119, STOPRUN

No. 120, SINGLEAX_LIFTFAST_OFF_MASTER

No. 121, SINGLEAX_STOP_LIFTOFF_MASTER

Explanation Activate tool-management commands (Ch. VDI signal).

Cause The NCK channel is in a state other than "ready"

Remedy Abort the program or process with the Reset key or wait for end of program.

Explanation Deactivate tool-management commands (Ch. VDI signal).

Cause The NCK channel is in a state other than "ready"

Remedy Abort the program or process with the Reset key or wait for end of program.

Explanation Selection of desired safety limitations (SGE) (always allowed).

Cause -

Remedy -

Explanation Stop run, i.e., the NCK has automatically stopped at an OPI-defined block

Cause 1. Controller is not in automatic mode.

Remedy -

Explanation Rapid lift with a single axis

Cause The axis is not controlled by the PLC.

Remedy -

Explanation Rapid lift with a single axis has been stopped

Cause The axis is not controlled by the PLC and the single axis is not executing a rapid lift

Remedy -

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 391 392

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Especificaciones Pagina 362

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl