Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 311)

Cycle alarms

06/2007 Overview of alarms

2-311

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414

Remedy: Change grinding wheel radius or workpiece radius

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61529 Channel %1 block %2: Dimensional notation INCH programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE412,

CYCLE413, CYCLE414, CYCLE415, CYCLE420

Remedy: Basic system MD $MN_SCALING_SYSTEM_IS_METRIC does not correspond to programmed G

command (G group 13).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61530 Channel %1 block %2: Default longitudinal position incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420

Remedy: Check longitudinal position parameter

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61531 Channel %1 block %2: Longitudinal position not registered in Z

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420

Remedy: Increase infeed path parameter

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61532 Channel %1 block %2: Value for _LAGE is incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414

Remedy: Correct parameter content for _LAGE

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61533 Channel %1 block %2: No length L1 entered under D...

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE416, CYCLE420

Remedy: Enter length L1 in the tool offset D of the grinding wheel

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61540 Channel %1 block %2: Incorrect D number / dresser D field active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE401, CYCLE402, CYCLE403,

CYCLE443

Remedy: A tool D number must be programmed that is < _GC_DNUM

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61541 Channel %1 block %2: Incorrect grinding wheel type entered

Parameters: %1 = Channel number

%2 = Block number, label channel number

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 391 392

Siemens SINUMERIK 802D sl Especificaciones Pagina 311

Comentarios a estos manuales

Siemens SINUMERIK 802D sl Especificaciones Pagina 311

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl