Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 229)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-229

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

20097 Axis %1 incorrect travel direction brake test

Parameters: %1 = Axis name, spindle number

Definitions: Due to the selected travel direction, the brake test for the current load torque is performed with an

incorrect torque.

Reaction: Alarm display.

Remedy: - Perform the brake test for the other travel direction

- Adjust drive MD 1192 better to the current weight ratio. The alarm will occur only if the current torque

deviates from MD 1192 by more than 5% when the brake is released.

- Activate the automatic determination of the load torque at the beginning of the brake test via MD

$MA_SAFE_BRAKETEST_CONTROL, Bit 0 = 1.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

20100 Channel %1: invalid configuration for digitizing

Parameters: %1 = Channel number

Definitions: - The digitizing function expects the definition of 3 geometry axes in the channel.

- At the available baud rate for a transmission of the actual positions and setpoint velocities between

the NC and the digitizing device, the interpolation cycle must be set to a minimum of 5ms.

Reaction: Interface signals are set.

Alarm display.

Remedy: Please inform authorized personnel / the service department.

- Define 3 geometry axes for the digitizing channel by means of machine data.

- Use an interpolation cycle greater than 5ms.

Program Con-

tinuation:

Switch control OFF - ON.

20101 Timeout during initialization of communication with the digitizer

Definitions: The attempt to synchronize the communications link to the digitizing unit and to transfer the machine

parameters was aborted after the preset timeout limit of 15 seconds was exceeded.

Reaction: Interface signals are set.

Alarm display.

Remedy: Check the connection to the digitizing unit (RS422 cable, supply voltage) and whether the digitizing

unit is switched on.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

20102 Channel %1: No or invalid trafo at digitizing active

Parameters: %1 = Channel number

Definitions: Prerequisite for the 3+2 axis digitizing is an active kinematic transformation. Permitted transformations

are the general 5-axis transformation and the universal inclinable head.

Reaction: Interface signals are set.

Alarm display.

Remedy: - Before digitizing, activate a permitted transformation.

- Select 3-axis mode for digitizing via machine data.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

20103 Channel %1: Digitizing module does not support 3+2 axes digitizing

Parameters: %1 = Channel number

Definitions: Prerequisite for 3+2 axis digitizing is that the NCU and the digitizing module both have the 3+2 axis

mode.

Reaction: Interface signals are set.

Alarm display.

Remedy: - SW update for the digitizing module.

- Select 3-axis mode for the digitizing via machine data.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 391 392

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Especificaciones Pagina 229

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl