Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 299)

Cycle alarms

06/2007 Overview of alarms

2-299

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61261 Channel %1 block %2: center offset too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The center offset on center drilling is larger than permissible.

Alarm triggered by following cycles: F_DRILL, F_DRILLD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter smaller center offset (see display machine data 9862).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61262 Channel %1 block %2: lead not possible with selected tool

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The lead of the tap does not match the programmed lead.

Alarm triggered by following cycles: F_DR_TAP, F_DRM_TA, F_TAP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a tap with the programmed lead.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61263 Channel %1 Block %2: Chained ShopMill program blocks not permissible

in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

The alarm is triggered by the following cycle: E_MANAGE

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61264 Channel %1 Block %2: Chained ShopTurn program blocks not

permissible in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

Alarm triggered by following cycle: F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 391 392

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Especificaciones Pagina 299

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl