Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 308)

Overview of alarms 06/2007

Cycle alarms

2-308

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61505 Channel %1 block %2: retraction path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase retraction path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61506 Channel %1 block %2: infeed path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase infeed path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61507 Channel %1 block %2: safety clearance < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61508 Channel %1 block %2: Incorrect default setting for shoulder position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61509 Channel %1 block %2: Incorrect default setting for dresser position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61510 Channel %1 block %2: Test run feed is active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413,

CYCLE415, CYCLE420

Remedy: Switch off test run feed

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61511 Channel %1 block %2: Incorrect shoulder position or tool edge D1/D2

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 391 392

Siemens SINUMERIK 802D sl Especificaciones Pagina 308

Comentarios a estos manuales

Siemens SINUMERIK 802D sl Especificaciones Pagina 308

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl