Siemens SINUMERIK 802D sl Especificaciones descargar pdf (Pagina 143)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-143

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: - Modify part program.

- Check tool data.

- Check machine data.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14745 Channel %1 block %2 centerless grinding not active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt has been made to switch off the centerless grinding function even though it was not active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14750 Channel %1 block %2 too many auxiliary functions programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: More than 10 auxiliary functions have been programmed in an NC block.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Check whether all auxiliary functions are necessary in one block - modal functions need not be

repeated. Create separate auxiliary function block or divide the auxiliary functions over several blocks.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14751 Channel %1 block %2 resources for motion synchronous actions not

sufficient (code: %3)

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Identifier

Definitions: Processing of motion synchronous actions requires resources that are configured via the machine

data $MC_MM_IPO_BUFFER_SIZE, $MC_MM_NUM_BLOCKS_IN_PREP,

$MC_MM_NUM_SAFE_SYNC_ELEMENTS and $MC_MM_NUM_SYNC_ELEMENTS. If these

resources are insufficient for executing the part program, then this alarm is issued. Parameter %3

shows which resource has run out:

Increase identifier <= 2: $MC_MM_IPO_BUFFER_SIZE or

$MC_MM_NUM_BLOCKS_IN_PREP.

Increase identifier > 2: $MC_MM_NUM_SYNC_ELEMENTS,

$MC_MM_NUM_SAFE_SYNC_ELEMENTS.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct part program or increase resources.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 391 392

Siemens SINUMERIK 802D sl Especificaciones Pagina 143

Comentarios a estos manuales

Siemens SINUMERIK 802D sl Especificaciones Pagina 143

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl