Siemens SIPART PS2 6DR50xx Instrucciones de operaciones descargar pdf (Pagina 140)

Parameterizing/addressing

10.4 Description of parameters

SIPART PS2 with and without HART communications

140 Operating Instructions, 09/2007, A5E00074631-07

Note

Matching the angles

Ensure that the values set in the transmission ratio selector and the "2.YAGL" parameter

match. If not, the value shown on the digital display does not match the actual position.

The factory setting is "33°".

See also

Overview of device components (Page 23)

10.4.1.2 Description of parameters 3 to 5

3.YWAY - display of the range of stroke

Use this parameter to set the value for the real range of stroke. This parameter is optional.

You must set this parameter only if the determined value in mm is to be displayed at the end

of the initialization process of a linear actuator.

Determine the value for the range of stroke as follows:

Fix the carrier pin on the lever at the desired position. This position on the lever has a

specific scaled value, e.g. 25. Set this scaled value in the "YWAY" parameter.

If you select the "OFF" parameter value, the real stroke is not displayed after initialization.

Note

The value set in the "YWAY" parameter must match with the mechanical range of stroke. Set

the carrier to the value of the actuator stroke. If the actuator stroke is not scaled, set it to the

next higher scaled value.

The factory setting is "OFF".

4.INITA - automatic initialization

Use this parameter to start the automatic initialization process. Select the "Strt" parameter

value. Then press the

increment button for at least five seconds. The sequence of the

initialization process from "RUN1" to "RUN5" is displayed on the lower line on the digital

display.

The factory setting is "NOINI".

5.INITM - manual initialization

Use this parameter to start the manual initialization process. Select the "Strt" parameter

value. Then press the

increment button for at least five seconds.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 241 242

Sin comentarios

Siemens SIPART PS2 6DR50xx Instrucciones de operaciones Pagina 140