Siemens SIPART PS2 6DR50xx Instrucciones de operaciones descargar pdf (Pagina 125)

Commissioning

9.3 Commissioning part-turn actuators

SIPART PS2 with and without HART communications

Operating Instructions, 09/2007, A5E00074631-07

125

Note

RANGE fault message

• The selected end position is beyond the permissible measuring range if the "RANGE"

message appears on the digital display. Correct the settings as follows: Move the

friction clutch until the digital display shows "OK". Press the operating mode button

again.

• Move the actuator spindle to another position using the

increment or decrement

buttons.

• Abort the manual initialization process by pressing the

operating mode button.

Switch to the "P manual mode" and adjust the actuator travel and the position

displacement sensor.

10. Determine the end position 2 of the actuator.

11. Move the actuator spindle to the desired position by pressing the

increment or

decrement buttons.

12. Accept the current position by pressing the

operating mode button.

13. The initialization process is automatically resumed. Displays for the initialization steps

from "RUN1" to "RUN5" are shown in the lower line on the digital display.

14. The following display indicates that the initialization has been completed successfully:

Aborting the manual initialization process

1. Press the operating mode button. The digital display shows the "INITM" parameter.

The positioner is in the "Configuration" mode.

2. Exit the "Configuration" mode. To do this, press the operating mode button

for at least

5 seconds.

3. The software status is displayed.

4. After releasing the

operating mode button, the positioner is in the "P manual mode",

i.e. the positioner has not been initialized.

Sin comentarios

Siemens SIPART PS2 6DR50xx Instrucciones de operaciones Pagina 125