Siemens SIPART PS2 6DR50xx Instrucciones de operaciones descargar pdf (Pagina 119)

Commissioning

9.2 Commissioning linear actuators

SIPART PS2 with and without HART communications

Operating Instructions, 09/2007, A5E00074631-07

119

6. Start the initialization process. To do this, press the increment button for at least 5

seconds until the digital display shows the following:

7. The current potentiometer position is shown on the digital display after 5 seconds.

Examples of the displayed potentiometer positions are given below:

8. Determine the end position 1 of the actuator spindle. Move the actuator spindle to the

desired position by pressing the

increment or decrement buttons. Accept the

current position of the actuator spindle by pressing the

operating mode button. The

following is shown on the digital display:

Note

"RANGE" fault message

The selected end position is beyond the permissible measuring range if the "RANGE"

message appears on the digital display. Correct the settings as follows:

• Move the friction clutch until the digital display shows "OK". Press the

operating

mode button again.

• Move the actuator spindle to another position using the

increment or decrement

buttons.

• Abort the manual initialization process by pressing the

operating mode button.

Switch to the "P manual mode" and adjust the actuator travel and the position

displacement sensor.

9. Determine the end position 2 of the actuator spindle. Move the actuator spindle to the

desired position by pressing the

increment or decrement buttons. Accept the

current position of the actuator spindle by pressing the

operating mode button.

Note

"Set Middl" fault message

The lever arm is not in the horizontal position if the "Set Middl" message appears on the

digital display. To correct the fault, set the reference point of the sine correction. Proceed

as follows:

1. Move the lever arm to the horizontal position by pressing the

increment or

decrement buttons.

2. Press the

operating mode button.

10. The initialization process is automatically resumed. Displays for the initialization steps

from "RUN1" to "RUN5" are shown in the lower line on the digital display.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 241 242

Comentarios a estos manuales

Sin comentarios

Siemens SIPART PS2 6DR50xx Instrucciones de operaciones Pagina 119

Comentarios a estos manuales

Relacionado con productos y manuales para Motor accesorios y componentes de vehículos Siemens SIPART PS2 6DR50xx