Siemens OSM Guía de usuario descargar pdf (Pagina 231)

CLIM Path

The CLIM to which the tape drive is configured.Configured CLIM

Indicates the slot and port location for the HBA controller (either SAS or FC).HBA Location

The logical unit number of the tape.LUN

Actions

Responsive Test

Verifies that the component is installed and responding.

Start

Puts the tape process in a state to accept regular I/O commands to the tape drive. When the Start

action completes, the drive is in the Started state.

Note that Start is a logical command and does not affect the hardware.

Stop

Puts the tape process in a state to disallow regular I/O commands to the tape drive. When the

Stop action completes, the tape drive is in the Stopped state.

Note that Stop is a logical command and does not affect the hardware.

Switch Process Pair

Switches processors of the primary and backup tape I/O processes.

Test Extended

Tests vary depending on the type of tape drive. This table lists the actions performed for each

supported tape device (listed by Product ID).

Actions PerformedProduct ID

N/A (The action can be initiated, but it will perform the same tests done by the Test Verify

action.)

CT9840

Data loopback test

Drum motor test

T514x

Servo interface loopback test

POSTT515x

ROM EDC verified

Queuing and enqueuing

Loader software reset

N/AT517x

Loop write-to-read. No tape (media) is required.T519x

Microprocessor library internal loopback testT9490

Servo processor self-test

Servo processor RAM test

The tape drive must be in the Stopped state to perform this action.

Tape 231

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 305 306

Sin comentarios

Siemens OSM Guía de usuario Pagina 231