Siemens OSM Guía de usuario Pagina 207
- Pagina / 306
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ME Firmware Update
Allows you to update the firmware file for the Maintenance Entity (ME) of the ServerNet Switch
Board.
Power Cycle
Power cycles the ServerNet Switch Board.
Replace
Launches the guided procedure to replace a ServerNet switch board in an IOAM or processor
switch.
NOTE: For an HP Integrity NonStop NS14000 or NS1000 system, the Replace action launches
a documented service procedure describing how to replace a ServerNet Switch Board unique to
that type of system.
Set LED State
Turns the ServerNet Switch Board LED on or off.
Soft Reset
Reinitializes the firmware without affecting the ServerNet Switch Board hardware or the routing
tables.
Service Processor (SP)
The service processor (SP) controls environmental and maintenance functions and acts as the master
of the serial maintenance bus (SMB). The service processor is a physical component of IOMF2)
CRUs.
Location in OSM Tree: System > Group > Module > IOMF2 > SP
Slot Location: Service processors are located in slots 50 and 55 of I/O enclosures (service side).
Example: SP (1.1.50)
Attributes
SP
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK. Values
Service State
Logical
The maximum processor configuration for the service processor. ValuesCurrent Topology
The state of the service processor:
Active (Primary): This is the active SP and it is available.
Device State
Active (Secondary): This is not the active SP, but it is available.
Firmware Update Mode: An SP firmware update is in progress.
In Test: Temporary state during power-on self-test.
Initializing: Temporary state during startup.
SP Stopped Responding to Peer:
The IPv4 address of the service processor.IPv4 Address
Service Processor (SP) 207
- HP Part Number: 527274-045 1
- Published: August 2014 1
- Contents 3
- 4 Contents 4
- Contents 5 5
- 6 Contents 6
- Contents 7 7
- 8 Contents 8
- Contents 9 9
- Contents 11 11
- 12 Contents 12
- Contents 13 13
- 14 Contents 14
- Contents 15 15
- 16 Contents 16
- Contents 17 17
- 18 Contents 18
- Contents 19 19
- 20 Contents 20
- Contents 21 21
- 22 Contents 22
- Contents 23 23
- 24 Contents 24
- Contents 25 25
- 26 Contents 26
- Contents 27 27
- 28 Contents 28
- Contents 29 29
- 30 Contents 30
- Contents 31 31
- What's New in This Guide 32
- About This Guide 40
- Related Reading 41
- 1 Introducing OSM 42
- OSM Low-Level Link 43
- OSM Event Viewer 43
- Installing OSM Components 44
- 3 Configuring OSM 45
- Configuring the Server 46
- Using OSM Bookmarks 49
- Running Multiple Sessions 49
- 5 Using the Management Window 51
- Management Window Example 52
- Internet Explorer Menu Bar 52
- OSM Menu Bar Options 52
- Display Menu 53
- Summary Menu 53
- Tools Menu 53
- Windows Menu 54
- Help Menu 54
- Rediscover Shortcut Menu Item 54
- Using the Physical View 55
- Using the Inventory View 56
- Using Shortcut Menus 57
- Interpreting Icons and Color 58
- Alarm Indicators 59
- Alarm Severity 59
- 6 Viewing Alarms 61
- Viewing the Alarms Dialog Box 62
- Viewing Alarm Details 62
- Suppressing Alarms 63
- Deleting Alarms 63
- 7 Viewing Attributes 64
- Suppression Persistence 65
- 8 Performing Actions 66
- Default Roles 67
- Performing an Action 68
- Aborting an Action 69
- Saving a Multi-Resource View 70
- Viewing Action Details 71
- Performing Firmware Updates 71
- Launching Guided Procedures 72
- Configuration Tool 73
- 9 Viewing Summary Reports 74
- Viewing a Resource Summary 75
- 10 Managing a System 76
- 11 System Resources 77
- Alarm Panel (Telco) 79
- ATM3SA (ATM Adapter) 80
- Firmware Update 81
- ATM Line 82
- Blade Complex 84
- Blade Element 85
- Check If Safe to Replace 87
- Check Reintegration Status 87
- Clear Forward Progress Log 87
- 88 System Resources 88
- Blade Element 89 89
- Blade Element Firmware 90
- Primitive State Firmware 91
- Disk Boot Firmware 91
- ISP1040 Firmware 91
- Blade System Board 92
- Blower (FCDM) 92
- CLIMs 99 99
- Attributes 100
- CLIMs 101 101
- CLIM-Attached Disks 102
- DIMM (CLIM) 103
- Firmware 104
- Physical 104
- Process Pair 104
- Disk Pair 104
- 106 System Resources 106
- Disk 107 107
- Disk (CLIM-Attached) 108
- Backup Path 109
- Primary Path 109
- Abort Backup Path 109
- 110 System Resources 110
- Disk (Fibre Channel) 111
- 114 System Resources 114
- Disk (Fibre Channel) 115 115
- Disk (SAS) 116
- DVD-ROM (Blade Element) 117
- Enclosure 120
- Configuration 121
- ESS Disk 122
- ESS Disk Collection 125
- External Disk 125
- 128 System Resources 128
- External Disk Collection 129
- Fan Assembly (Blade Element) 130
- Fan (CLIM) 131
- Fan (IOAM) 131
- Fan (Processor Switch) 132
- Fan (SAS Disk Enclosure) 132
- Fan (VIO) 133
- FC Card (CLIM) 133
- FC-AL I/O Module 134
- FCDM Collection 138
- Responsive Test 140
- Test Verify 140
- Removing the FCSA 140
- FCSA 141 141
- FCSA FSAC 142
- Fibre Channel Router 144
- Associated Device 145
- Physical Location 145
- Link to Web Interface 145
- Rediscover 145
- Stop Monitoring 145
- G4SA PIF 147
- G4SA SAC 149
- Group (IOMF2 or VIO) 152
- Group (IOAM, Fabric, G16SE) 153
- Hard Disk (CLIM) 154
- InfiniBand HCA Card (CLIM) 154
- Internal ServerNet Fabric 155
- IO Module 156
- IOAM (I/O Adapter Module) 156
- IOAM Enclosure 157
- IOMF2 (I/O Multifunction 2) 159
- Logical Processor 162
- X Fabric Connection 163
- Y Fabric Connection 163
- Disable Processor Freeze 163
- 164 System Resources 164
- Maintenance PIC 165
- Maintenance Switch 165
- Memory Card (Blade Element) 166
- Set Physical Location 168
- Monitored Service LAN Devices 169
- Motherboard (CLIM) 169
- NIC (CLIM) 170
- Optical Extender PIC 171
- PCI Riser 172
- Clear Loopback Test 173
- Enable/Disable Port 173
- External Loopback Test 173
- Internal Loopback Test 173
- Power Supply 176
- Power Supply 177 177
- Removing the Power Supply 178
- Power Supply 179 179
- Power Supply (Blade Element) 180
- Power Supply (CLIM) 181
- Power Supply (FCDM) 181
- Power Supply (IOAM) 182
- Configure Power Source as AC 183
- Configure Power Source as UPS 183
- Power Supply (VIO) 185
- Processor (CLIM) 187
- Processor Blade 187
- Processor Components 189
- LSU Logic Board 190
- Processor Switch Module 192
- Write LCD Line 194
- SAS Card (CLIM) 196
- SAS Disk Enclosure 197
- SAS Disk Enclosures 199
- SCSI Controller 199
- ServerNet PIC 201
- ServerNet Port 202
- ServerNet Switch Board 205
- Service Processor (SP) 207
- SP Firmware 208
- SCSI Boot Code Firmware 208
- Smart Array Controller (CLIM) 209
- SNDA (ServerNet/DA) 210
- SSAC (SCSI SAC) 211
- Storage Router 211
- SWAN / SWAN2 213
- SWAN Battery 215
- SWAN CLIP 216
- SWAN Collection 218
- SWAN FAN 218
- SWAN LAN Logic Board (LANLB) 218
- SWAN Line 219
- SWAN Path 220
- SWAN (Power Supply) 221
- Operating System 222
- Data Collection Services 222
- System Load Configuration 222
- 224 System Resources 224
- System 225 225
- 226 System Resources 226
- System 227 227
- Tape Collection 228
- Controller Path 230
- Unknown CRU 233
- VIO FCSA 234
- VIO G4SA 236
- VIO Logic Board 237
- ME Firmware 238
- Dump Memory 238
- VIO Module 239
- Common Attribute Values 242
- Compare State (Other) 243
- Device State 243
- Enabled State 243
- Group Type 244
- Path State 244
- Power State 244
- Processor State 245
- Processor Type 245
- Service State 246
- Tape Types 247
- Topology 248
- BladeCluster Solution 249
- Monitoring a Cluster 250
- Updating Cluster Switches 251
- 13 Cluster Resources 254
- 6780 Switch Module 255
- AC Transfer Switch 257
- BladeCluster 257
- External ServerNet Fabric 259
- Remote 6770 Switch 261
- ServerNet Cluster 262
- ServerNet Local Node 264
- ServerNet Remote Node 264
- ServerNet II Switch 265
- Switch Fan 267
- Switch Group 268
- Switch Logic Board 269
- Switch PIC 271
- Switch Power Supply 272
- Switch-to-Node PIC 273
- Switch Node Port 274
- Switch-to-Switch PIC 275
- Switch Port 276
- UPS (6770 Switch Module) 277
- Port Connectivity Status 279
- Identifying Your Update Type 280
- Updating Star Topologies 280
- Updating Star Topologies 281 281
- 288 Index 288
- 290 Index 290
- 292 Index 292
- 294 Index 294
- Online Help 295
- Registering CLIMs 305
Relacionado con productos y manuales para Redes Siemens OSM
Redes Siemens AC65 Especificaciones
(118 paginas)
(118 paginas)
Redes Siemens SIMATIC TIWAY 1 Manual de usuario
(138 paginas)
(138 paginas)
Redes Siemens CP 1515 Manual de usuario
(16 paginas)
(16 paginas)
Redes Siemens SPC3 Manual de usuario
(6 paginas)
(6 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.050 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales