Siemens OSM Guía de usuario descargar pdf (Pagina 182)

Attributes

Power Supply

Displayed in the Attributes tab and Attributes dialog box only if the value is

something other than OK. Values

Service State

Physical

Indicates whether or not the power supply’s (amber) fault LED is blinking.

Value: Blinking or Off

LED State

The vendor hardware type.Type

Logical

Whether the power source is On or Off.AC Power State

The state of the component as known to the operating system on the server.

Values

Device State

A code that identifies the generation of the component provided by its

supplier.

Vendor Hardware Revision

Actions

Blink LED Off

Turns off the blinking of the power supply’s (amber) fault LED.

SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED OFF

Blink LED On

Causes the power supply’s (amber) fault LED to start blinking.

SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED ON

Replace

Displays the procedure for replacing the power supply.

Power Supply (IOAM)

Supplies power to the IOAM. There are two IOAM power supply units in each IOAM.

For information on how to replace an individual Power Supply, see the Support and Service >

Service Procedures collection in NTL.

NOTE: If a ServerNet switch board is not present, the IOAM power supplies will not appear in

OSM.

Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > Power Supply

Example: Power Supply (13.2.15)

Attributes

IOAM Power Supply

Displayed in the Attributes tab and Attributes dialog box only if the value is

something other than OK. Values

Service State

182 System Resources

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 305 306

Sin comentarios

Siemens OSM Guía de usuario Pagina 182