Siemens OSM Guía de usuario descargar pdf (Pagina 115)

Responsive Test

Verifies that the disk drive is installed and responding.

Save as System Load Configuration

Specifies, within OSM, this disk as an alternate system load volume. For NonStop BladeSystem

NB54000c and NB56000c only, if the action passes and a valid core license file is present in

$SYSTEM, OSM offers to copy the license file copied to each new alternate system disk.

You can specify up to four such alternate system load configurations. Each one is displayed under

the system attributes in the OSM Service Connection and can be selected from within the System

Load dialog box in the OSM Low-Level Link.

NOTE: With OSM Low-Level Link T0633 AAQ and later, you can also save system configuration

files on the system console. Those saved configurations are not displayed as attributes values in

the OSM Service Connection, but can be used during the system load operations in the Low-Level

Link. For more information, see the OSM Low-Level Link online help.

Spin Down

Stops the physical spinning of the disk drive. This should be done before removing a disk drive.

Both paths must be down for the action to succeed.

Spin Up

Starts the physical spinning of the disk drive.

Start Backup Path

Starts the backup path to this disk drive. When the Start action completes, the backup path is in

the Started state.

This action fails if both paths to this disk are down and the mirrored disk is Up. For more information,

see Start Disk.

Start Disk

Use this action to start all paths to the disk drive only when:

• The disk paths are in a Down state. (Hard Down states require a reset action, either Reset

Disk, Reset Primary Path, or Reset Backup Path as appropriate.)

• Its mirrored disk is not currently Up. The Start Disk action is designed to fail if the mirrored

disk is already in an Up state because the mirror and primary disk volumes can have different

data and require a revive operation. To revive and bring up the disks properly, use the OSM

Start Volume action or SCF START DISK command.

When the action completes successfully, all paths to the disk are in the Started state.

Start Primary Path

Starts the primary path to this disk drive. When the Start action completes, the primary path is in

the Started state.

This action fails if both paths to this disk are down and the mirrored disk is Up. For more information,

see Start Disk.

Start Volume

Starts all paths for both the primary and mirror drives of this volume unless they are in a Hard

Down state. Disk paths in a Hard Down state require a reset action first (either Reset Disk, Reset

Primary Path, or Reset Backup Path as appropriate).

Disk (Fibre Channel) 115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 305 306

Sin comentarios

Siemens OSM Guía de usuario Pagina 115