Siemens SIMATIC TI500 Especificaciones descargar pdf (Pagina 145)

5-4

Installing Remote Base Controllers—RBCs SIMATIC 545/555/575 System Manual

Installation (continued)

Use the following steps to install an RBC in a Series 505 base.

WARNING

Installing or removing an RBC from a powered-up base disrupts your process.

Installing or removing an RBC from a powered-up base could cause unexpected

operation which could cause death or serious injury to personnel, and/or

damage to equipment.

Ensure that all power is disabled before installing or removing the RBC.

CAUTION

The RBC is sensitive to, and can be damaged by, electrostatic discharge.

Ensure that personnel make contact with a static-dissipative pad and/or wear a

grounded wrist strap when handling the RBC.

1. Verify that all jumper and dipswitch selections are correct.

2. Disconnect power to the base.

3. Position the RBC so that the bezel is facing you.

4. Grasp the top and bottom of the RBC.

5. Carefully push the RBC into the slot until it mates with the backplane

connector.

6. Tighten top and bottom bezel screws.

CAUTION

RBCs are not designed to be installed in VME bases.

Doing so results in damage to equipment.

Never attempt to install any RBC in a VME base.

To remove the RBC, complete the following steps.

1. If cables are attached, remove them from the front of the RBC.

2. Disconnect power to the base.

3. Loosen top and bottom bezel screws.

4. Carefully pull the RBC from the base.

Installing and

Removing the RBC

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 321 322

Sin comentarios

Siemens SIMATIC TI500 Especificaciones Pagina 145