Siemens SIMATIC TI500 Especificaciones descargar pdf (Pagina 107)

4-24

Installing 575 System Hardware SIMATIC 545/555/575 System Manual

4.10 Configuring the CPU

Before installing the 575–2105 or 575–2106 CPU board, you must configure

the dipswitch on the 575 CPU board. The configuration options override any

dipswitch settings that you may have made on an HSIO annex card or a

PROFIBUS-DP annex card.

Figure 4-15 shows the position of the configuration dipswitch on the

575–2105 and 575–2106 CPU boards. Table 4-3 lists the dipswitch

configuration options.

Dipswitch

Figure 4-15 Position of Configuration Dipswitch on 575–2105 and –2106

CPUs

If you are using a 575–2104 CPU, you must configure the dipswitch located

on the HSIO or PROFIBUS-DP annex card. Refer to Section 4.11.

Figure 4-16 shows the location of the dipswitch on the 575–2126 annex card.

Figure 4-17 shows the location of the dipswitch on the 505–CP5434–DP

annex card. Table 4-3 lists the dipswitch configuration options.

NOTE: All switches have the same meaning for both annex cards, except for

switches 1–2. For the 575–2126 annex card, these switches must be in the

correct position (On) or the 575 CPU will not be able to communicate with

the remote bases. Table 4-3 identifies the correct switch settings for each

annex card.

Configuring the

575–2105/–2106

CPU

Configuring the

575–2104 CPU

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 321 322

Sin comentarios

Siemens SIMATIC TI500 Especificaciones Pagina 107