Siemens IP-Module Manual descargar pdf (Pagina 81)

IP 266 Machine Data, Modes and Traversing Programs

Reference coordinate

The reference point is used to calibrate the axis. Its location can be specified via

the "Set/Approach to reference point" mode (see Section 5.3.5). The "reference

coordinate" machine data parameter is used to assign a value to this position.

The value must lie within the maximum range limits. When you define the

reference point coordinate, you also define the following coordinates:

• coordinate basic origin

• software limit switches

You can make absolute target specifications only in a system with a defined

reference point.

5.1.4 Speeds

The speeds specified in the machine data define the true speeds of the drive

system, and depend on

• the motor rotational speed

• the number of encoder pulses per revolution

• the travel per encoder revolution

The absolute values for all speeds must be less than or equal to the maximum

speed. Input values must be in the range from 1 to 65,000. Depending on the

parameter assignments, the IP expects values in [mm/min], [deg/min] or

[0.1 inch/min].

Maximum speed

Under IP 266 control, the drive reaches the maximum speed with a setpoint of

±10 V

CAUTION :

The maximum speed must be computed from the technical specifications for

the complete drive system (motor, axis, encoder, and so on).

EWA 4NEB 812 6057-02

5-9

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 359 360

Sin comentarios

Siemens IP-Module Manual Pagina 81