Siemens IP-Module Manual descargar pdf (Pagina 332)

Troubleshooting IP 266

Troubleshooting

Error Code

Cross-

Reference

Zero offset too large

Every zero offset may assume values in the range +/-32767.999 mm.

Among other things, a zero offset changes the coordinates of the software

limit switches. Each offset value must be such that the coordinates of the

software limit switches still lie in the range from +/-32767.999 mm

(+/-32767.999 inches, +/-32767.999 degrees) after being shifted.

F0C Wrong module number

When <F1> (Start) is pressed in the PRESETS form, the COM 266 software

executes a module identification test. When a set of machine data is

entered on the IP 266, the specified module number is compared with the

module number in the machine data. The machine data must contain the

same number as the one entered.

F0D

Wrong tool offset

A tool offset is restricted to +/-32767.999. The coordinate of the software

end limit switch plus zero offset and the coordinate of the software start

limit switch plus zero offset must lie in the range +/-32767.999 mm

(+/-32767.999 inches, +/-32767.999 degrees). Remember that the zero

offset is a signed value. In the case of a rotary axis, the tool offset must also

lie within the traversing range.

F0E

Position tolerance out of range

The tolerance range for zero-speed monitoring extends from 0.001 to

64.999 mm, and must also be less than the maximum following error.

F0F

Inadmissible inputF10

Section 5.1.1

Section 5.1.7

Section 5.1.6

10-6

EWA 4NEB 812 6057-02

1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 359 360

Sin comentarios

Siemens IP-Module Manual Pagina 332