Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 269)

Cycle alarms

06/2009 Overview of alarms

2-269

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Request to load a swivel head.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

62183 [Channel %1: ] Block %2 : unload inclinable head: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Reaction: Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

62184 [Channel %1: ] Block %2 : replace inclinable head: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Reaction: Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

62185 [Channel %1: ] Block %2 : angle adapted to angle grid: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: %4 difference angle with Hirth tooth system

Alarm triggered by following cycle: CYCLE800.

Remedy: Check installation and start-up of the swivel cycle CYCLE800.

62186 [Channel %1: ] Block %2: Swiveling in JOG --> active WO G%4 and basic

frames contain rotations

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE800.

Note for 62186 and 62187:

Set and active error messages 62186 and 62187 with GUD7 parameter _TC_FR:

100th position 0xx -> no error analysis 62186 61287

1xx -> error analysis 62186 - active WO G%4 and basic frames include rotations

2xx -> error analysis 62187 - several active basic frames (G500) include rotations

3xx -> error analyses 62186 and 62187.

Remedy: For %4 of the active WO see notes for 62186 and 62187.

62187 [Channel %1: ] Block %2: Swiveling in JOG --> several active basic

frames (G500) contain rotations

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Several active basic frames (G500) include rotations.

Alarm triggered by following cycle: CYCLE800.

Note on 62186 and 62187

Setting of the activation of error messages 62186 and 62187 with GUD7 parameter _TC_FR:

100's place 0xx -> no error evaluation 62186 61287

1xx -> error evaluation 62186 - active NV G%4 and basic frames include rotations

2xx -> error evaluation 62187 - several active basic frames (G500) include rotations

3xx -> error evaluation 62186 and 62187

Remedy: See notes for 62186 and 62187.

62200 [Channel %1: ] Block %2: Start spindle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Stop prior to thread machining, as the spindle is in stop position.

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 269

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl