Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 201)

Cycle alarms

06/2009 Overview of alarms

2-201

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61112 [Channel %1: ] Block %2: Tool radius negative

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles: CYCLE72,

CYCLE76, CYCLE77, CYCLE90.

Remedy: Change the tool radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61113 [Channel %1: ] Block %2: Parameter _CRAD too large for corner radius

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following

cycle: POCKET3.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Parameter must be reduced.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61114 [Channel %1: ] Block %2: Machining direction G41/G42 incorrectly

defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The machining direction of the cutter radius compensation G41/G42 has been incorrectly selected.

Alarm triggered by following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change machining direction.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61115 [Channel %1: ] Block %2: Approach or retract mode(straight / circle /

plane / space) incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach or retract mode to/from the contour has been incorrectly defined. Alarm triggered by

following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _AS1 or _AS2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61116 [Channel %1: ] Block %2: Approach or retract path = 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach or retract path has been specified with zero. Alarm triggered by following cycle:

CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 201

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl