Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 227)

Cycle alarms

06/2009 Overview of alarms

2-227

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61271 [Channel %1: ] Block %2: Chamfer width > tool radius

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer width larger than tool radius.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a larger tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61272 [Channel %1: ] Block %2: Insertion depth too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too small.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61273 [Channel %1: ] Block %2: Insertion depth too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too large.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61274 [Channel %1: ] Block %2: Invalid tool angle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Invalid tool angle.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check tool angle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61275 [Channel %1: ] Block %2: Target point violates software limit switch!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Due to a swivel action, the end point is outside the software limit switches.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 227

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl