Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 104)

Overview of alarms 06/2009

NCK alarms

2-104

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Correct the NC part program. Only the two geometry axes may be programmed that establish the cur-

rent machining plane.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14280 [Channel %1: ] Block %2 polar coordinates programmed incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The end point of the displayed block has been programmed both in the polar coordinate system (with

AP=..., RP=...) and in the Cartesian coordinate system (axis addresses X, Y,...).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the NC part program - the axis motion may be specified in one coordinate system only.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14300 [Channel %1: ] Block %2 overlaid handwheel motion activated incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Handwheel override has been called up incorrectly:

- 1st For positioning axes:

- Handwheel override programmed for indexing axes,

- No position programmed,

- FA and FDA programmed for the same axis in the block.

- 2nd For contouring axes:

- No position programmed,

- G60 not active,

- 1st G group incorrect (only G01 to CIP).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14320 [Channel %3: ] Axis %4: handwheel %1 used twice (%2)

Parameters: %1 = Handwheel number

%2 = Use

%3 = Channel

%4 = Axis

Definitions: Informational alarm indicating that the mentioned handwheel is used twice:

The second parameter provides the explanation:

1: Block with axial handwheel override for this axis cannot be executed as the handwheel

for this axis performs a DRF movement

2: Block with velocity override of the path cannot be executed as the handwheel performs

a DRF movement for this axis of the path

3: Block with contour handwheel cannot be executed as the handwheel performs a DRF movement

for this axis of the path

4: PLC axis with axial handwheel override cannot be started immediately as the handwheel performs

a DRF movement for this axis

5: The axis is a reciprocating axis with axial handwheel override; the reciprocating movement cannot

started immediately as the handwheel performs a DRF movement for this axis

6: The DRF movement for this axis cannot be executed as an axial handwheel override is active for

this axis with the handwheel

7: The DRF movement for this axis cannot be executed as a velocity override of the path with

the handwheel is active and the axis belongs to the path

8: The DRF movement for this axis cannot be executed as the contour handwheel is active with

this handwheel and the axis belongs to the path

9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with handwheel

override that is active with this handwheel

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 104

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl