Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 229)

Cycle alarms

06/2009 Overview of alarms

2-229

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61280 [Channel %1: ] Block %2: Mirroring in WO %4 missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If the program starts with a counterspindle movement, a work offset with mirroring will have to be

selected.

Alarm triggered by following cycle: F_SUB_SP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select the mirroring for the work offset used.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61281 [Channel %1: ] Block %2: starting point of machining outside retraction

planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61282 [Channel %1: ] Block %2: end point of machining outside retraction

planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The end point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61283 [Channel %1: ] Block %2: direct approach not possible, as tool change

required

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: First execute a manual tool change, then restart the block search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 229

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl