Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 265)

Cycle alarms

06/2009 Overview of alarms

2-265

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: --

61910 [Channel %1: ] Block %2: Helix violates contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61911 [Channel %1: ] Block %2: Several approach points required

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61912 [Channel %1: ] Block %2: No path to generate

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: --

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61913 [Channel %1: ] Block %2: No residual material generated

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61914 [Channel %1: ] Block %2: Programmed helix violates contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61915 [Channel %1: ] Block %2: Approach/retract motion violates contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61916 [Channel %1: ] Block %2: Ramp path too short

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61917 [Channel %1: ] Block %2: Residual corners may remain with overlapping

of less than 50%

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61918 [Channel %1: ] Block %2: Cutter radius for residual material too large

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 265

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl