Siemens SINUMERIK 802D sl Manual del operador descargar pdf (Pagina 211)

Cycle alarms

06/2009 Overview of alarms

2-211

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61187 [Channel %1: ] Block %2: block search mode not allowed -> select block

search with contour calculation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE800.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select block search with contour calculation.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61188 [Channel %1: ] Block %2: No axis name agreed for 1st rotary axis ->

Start-up check CYCLE800

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No axis name was specified for the 1st rotary axis. Alarm triggered by following cycles: CYCLE800.

Remedy: Check installation and start-up of the swivel cycle CYCLE800.

No entry under rotary axis 1 identifier.

61189 [Channel %1: ] Block %2: invalid rotary axis positions

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE800.

Remedy: Swivel in JOG, swivel mode direct, check position of rotary axes or start-up of swivel cycle CYCLE800

rotary axes, check area of angles.

61190 [Channel %1: ] Block %2: unable to retract in tool direction --> error

code: %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggered by the following cycles: CYCLE800.

Remedy: Error code:

A=0xxx -> Parameter CYCLE800 _FR incorrect or retraction variant not created in start-up

CYCLE800.

A=1xxx -> No applicats available $P_AXN3

A=2xxx -> Maximum retraction path incorrect, see GUD _TC_P[8]

A=3xxx -> Incremental retraction path incorrect, see GUD _TC_P[8

A=4xxx -> Retraction in tool direction, NC function CALCPOSI reports error

No reference for tool axis (e.g. Z with G17) approached

B = Input parameter _FR*100

CD = Start-up parameter $P_TCARR37[] (7th, 8th decimal place)

See table Coding retraction modes

61191 [Channel %1: ] Block %2: 5 axis transformation not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 339 340

Comentarios a estos manuales

Sin comentarios

Siemens SINUMERIK 802D sl Manual del operador Pagina 211

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Siemens SINUMERIK 802D sl