Siemens HydroRanger 200 Manual de instrucciones descargar pdf (Pagina 40)

Page 26 HydroRanger 200 – INSTRUCTION MANUAL 7ML19981FC01

mmmmm

Operation

Activating the HydroRanger 200

All the instructions in the following procedures apply to the hand programmer and

assume that the HydroRanger 200 is activated.

1. Power the HydroRanger 200.

2. Point the programmer at the unit and press PROGRAM

3. Press DISPLAY .

Changing Parameters

1. Starting in RUN mode, press PROGRAM and then press DISPLAY to put the

unit into PROGRAM mode.

2. Press DISPLAY to select the Parameter Number field.

3. Enter the Parameter Number (e.g. 110). After the third digit is entered, the parameter

value is shown.

4. Enter the new value, and press ENTER . The HydroRanger 200 interprets the

value, either accepting or replacing it with a valid value.

Helpful Hints

• For parameters P001 to P007, press a single digit (1–7) and then press DISPLAY

to show that parameter.

• The ? icon indicates that the HydroRanger 200 has accepted the value but that it

conflicts with other values entered. Double-check your programming.

• By default, the SCROLL arrows show only the Quick Start parameters and

any that have been changed.

• P733 sets all parameters to be scroll-accessed.

Security

The Lock parameter (P000) secures the HydroRanger 200 against parameter changes.

The unit can still be put into PROGRAM mode when locked, and parameter values can be

viewed, but no parameter values can be changed.

Note: Power up display

• preset to display distance from the face of the transducer to the material

• transducer selection is preset for the XPS-10

• empty distance is preset to 5m

Note: If Parameter Value alteration is not permitted, access the Lock parameter

(P000) and enter the security code, (see

Security

below).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 255 256

Sin comentarios

Siemens HydroRanger 200 Manual de instrucciones Pagina 40