Siemens ET 7Y Series Especificaciones descargar pdf (Pagina 46)

Getting Started

2-20

ET 200S IM 151-7 CPU Interface Module

A5E00058783-04

Se-

quence

ResultAction

5 Start the Set PD/PC Interface program as described under step 3, point 4. Change the

configuration of the PD/PC interface as follows:

6 Confirm the settings with OK and close the ”Set PD/PC Interface” program.

7 Open the front panel of the S7-300-CPU.

Connect the IM 151-7 CPU to the DP interface of the S7-300-CPU using a

PROFIBUS-DP cable. Make sure that the terminating resistor is switched on at both

connectors.

Remove the connector of the PD cable from the MPI interface of the S7-300-CPU and connect

it to the bus connector of the PROFIBUS-DP cable at the S7-300-CPU. Screw on the

connector securely.

Close the front panel of the S7-300-CPU if possible.

8 In the SIMATIC Manager, navigate to the block

container of the ET 200S.

Select the block container in the left-hand side of

the window.

In the PLC menu of the SIMATIC Manager, select

the Load command to transfer the program and the

hardware configuration to the IM 151-7 CPU.

Confirm all windows that appear with Yes.

The program and configuration are

downloaded from the PD to the

IM 151-7 CPU.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 213 214

Sin comentarios

Siemens ET 7Y Series Especificaciones Pagina 46