Siemens ET 7Y Series Especificaciones descargar pdf (Pagina 29)

Getting Started

2-3

ET 200S IM 151-7 CPU Interface Module

A5E00058783-04

2.1 1st step: Installing the IM 151-7 CPU (ET 200S) and

S7-300

Se-

quence

Description

1 Install the S7-300 as described in Installation Manual for Automation System S7-300, Setting

Up.

2 If you want to operate the IM 151-7 CPU using a dedicated power supply, hang the PS in the

mounting rail of the S7-300 and push in until it engages.

3 Hang the IM 151-7 CPU in the mounting rail and push in until it engages.

4 Hang the TM for the PM in the mounting rail to the right of the IM 151-7 CPU and push in until

it engages.

5 Push the TM to the left until it engages audibly in the IM 151-7 CPU.

6 Repeat points 3 and 4 for two TMs for the electronics modules and finally for the terminating

module (does not engage in the mounting rail).

7 Push the PM into the appropriate TM until it engages.

8 Push the DI into the free TM on the left until it engages.

9 Push the DO into the last free TM until it engages.

10 Insert the micro memory card into the IM 151-7 CPU (must be installed otherwise the system

will not work). A micro memory card with unknown content should be erased beforehand at the

programming device.

FRCE

RUN

STOP

Figure 2-1 Installing the IM 151-7 CPU (ET 200S)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 213 214

Sin comentarios

Siemens ET 7Y Series Especificaciones Pagina 29