
Troubleshooting
107
Siemens Building Technologies
Fire Safety & Security Products 12.2008
10 Troubleshooting
Problem Possible solution
No power
z Check power cord connections.
z Confirm that there is power at the outlet.
No live video
z Check camera video cable and connections.
z Check monitor video cable and connections.
z Confirm that the camera has power.
z Check camera lens settings.
Live video very bright If a cable is attached to the “Loop” connector, make certain it is
connected to a properly terminated device.
DVR has stopped recording If hard disk drive is full, you will either need to delete video or set
the DVR to the Overwrite Mode.
The icon
displays, however,
the DVR is not recording
When the DVR is in the Pre-Event recording mode, the yellow
and
display when there is no event, and the DVR is not
recording. The red
and display when any event occurs and
the DVR starts recording.
11 Disposal
All electrical and electronic products should be disposed of separately from the
municipal waste stream via designated collection facilities appointed by the
government or the local authorities.
This crossed-out wheeled bin symbol on the product means the product is covered by
the European Directive 2002/96/EC.
The correct disposal and separate collection of your old appliance will help prevent
potential negative consequences for the environment and human health. It is a
precondition for reuse and recycling of used electrical and electronic equipment. For
more detailed information about disposal of your old appliance, please contact your
city office, waste disposal service or the shop where you purchased the product.
Comentarios a estos manuales