Siemens IEEE802.11 Instrucciones de operaciones descargar pdf (Pagina 211)

Configuring with Web Based Management

5.6 "Interfaces" menu

SCALANCE W770/W730 to IEEE 802.11n Web Based Management

Configuration Manual, 11/2014, C79000-G8976-C323-03

211

●

Partner ID Type

Specify the type of WDS communication.

– MAC Address

The MAC address is used. The "Partner WDS ID" input box is grayed out. In "Partner

MAC", enter the MAC address of the WDS partner.

– WDS ID

The WDS ID is used. The "Partner MAC" input box is grayed out. In "Partner WDS

ID", enter the WDS ID of the WDS partner. Use this option if you want to replace the

access point later using the C-PLUG or KEY-PLUG.

●

Partner MAC

Enter the MAC address of the WDS partner.

●

Partner WDS ID

Enter the WDS ID of the WDS partner.

For the WDS ID, ASCII code 0x20 to 0x7e is used.

Note

Matching security settings in WDS mode

In WDS mode, make sure that the security settings match up for all devices involved. If

settings are incorrect or not co

mpatible on the individual devices, no data exchange is

possible due to incorrect authentication. Avoid the "Auto" setting in the "Security Settings"

tab of the Basic Wizard, because with this setting, synchronization of the security settings

between the a

ccess points is not possible.

Note

In WDS operation, the following restrictions apply to all access points involved:

•

All access points that will communicate with each other must use the same channel, the

same transmission procedure and the same data rate.

•

You can select either WEP or WPA(2)-PSK as the encryption method.

You configure the security settings in the assigned VAP interface: "Security > WLAN >

Basic"

You cannot use authentication with a RADIUS server for a WDS connection.

•

In the IEEE 802.11h transmission mode, it is not practical to select the WDS mode. In

WDS mode, all access points must use the same channel. If a signal from a primary user

is detected by an access point, the channel is changed automatically and the existing

connection is then terminated.

Procedure

1. Select the required VAP interface from the "Connection over"drop-down list.

2. Select the entry "WDS ID" from the "Partner ID Type"drop-down list.

3. In the "WDS ID" input box, enter the WDS ID of the WDS partner. The "Partner MAC"

input box is grayed out.

4. Click the "Set Values" button.

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 291 292

Comentarios a estos manuales

Sin comentarios

Siemens IEEE802.11 Instrucciones de operaciones Pagina 211

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Siemens IEEE802.11