Siemens GC..M.. Manual de instalación descargar pdf (Pagina 14)

Installation

Introduction

This section is intended for installation personnel. After completing these procedures, the Maxum II will

be ready for startup. To ensure a safe and trouble-free installation, follow all instructions and associated

advisories. The Maxum II has special instructions in the custom documentation and on tags placed on the

unit. These must be followed as well to ensure safe operation of the Maxum II.

CAUTION Ensure that all AC Power (Mains) specification requirements and advisories are met.

Failure to do so, and operating the equipment in a manner not specified, may impair the safety

protection provided by the equipment. Be sure to review the information provided on safety

practices and precautions (page v).

WARNING Specific additional instructions are provided with tags placed on the Maxum II and in

the custom application drawing package noted below. Installation should include all of the items

noted in both of these as well as the manuals. The tagging and custom application drawing

packages are unique to the particular Maxum II.

Custom Application Drawing Package

Included with your analyzer is a custom application drawing package that provides drawings and

information pertinent only to your analyzer. Because procedures in this manual reference the drawing

package, you should have this package readily available during installation.

Typical drawings included are:

 System Block and Utility Requirements

 System Outline and Dimensional Drawings

 Sampling System – Plumbing and Spare Parts List

 Sampling System Dimensional Diagram

 Sampling Probe

 Electronic Controller – Internal Layout

 Applicable Wiring Diagrams

 Oven Plumbing Diagram – Sensor Near Electronics

 Recommended Spare Parts - Analyzer

 Manufacturing Test Charts

 Stream Composition Data

 Data Base

Considerations for Pulsed Discharge Detector Installation

Instructions

Special installation considerations may be required for installation, power, gas supply, wiring, etc. in

association with the Valco Pulsed Discharge Detector. If your Maxum II is equipped with this type of

detector, refer to the custom documentation provided with the Maxum II and the Instruction Manual for

the Pulsed Discharge Detector that is available from Valco Instruments Co. Inc.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Sin comentarios

Siemens GC..M.. Manual de instalación Pagina 14