
Siemens TCP/IP Ethernet Driver Help
Data Access Errors
Error Code Description
0xFF No error
0x01 Hardware fault
0x03 Illegal object access
0x05 Invalid address (incorrect variable address)
0x06 Data type is not supported
0x07 Invalid data size/too much data
0x0A Object does not exist or length error
Address Validation Error Messages
The following error/warning messages may be generated. Click on the link for a description of the message.
Address <address> is out of range for the specified device or register.
Array size is out of range for address <address>.
Array support is not available for the specified address: <address>.
Data type <type> is not valid for device address <address>.
Device address <address> contains a syntax error.
Device address <address> is read only.
Missing address.
Address <address> is out of range for the specified device or register.
Error Type:
Warning
Possible Cause:
A tag address that has been specified dynamically references a location that is beyond the range of supported
locations for the device.
Solution:
Verify the address is correct; if it is not, re-enter it in the client application.
Array size is out of range for address <address>.
Error Type:
Warning
Possible Cause:
A tag address that has been specified dynamically is requesting an array size that is too large for the address
type or block size of the driver.
Solution:
Re-enter the address in the client application to specify a smaller value for the array or a different starting point.
Array Support is not available for the specified address: <address>.
Error Type:
Warning
Possible Cause:
A tag address that has been specified dynamically contains an array reference for an address type that doesn't
support arrays.
Solution:
Re-enter the address in the client application to remove the array reference or correct the address type.
www. kepware.com
64
Comentarios a estos manuales