Siemens IP-Module Especificaciones descargar pdf (Pagina 6)

Siemens TCP/IP Ethernet Driver Help

Device Setup

Supported Devices

S7-200 via CP243

S7-300 via CP343

S7-400 via CP443

S7-1200*

S7-1500*

S7-300 via NetLink

S7-400 via NetLink

*This device has a built-in Ethernet module.

Supported NetLink Cables and Gateways

NT 50-MPI

NL 50-MPI

NL-MPI

Connection Timeout

This parameter specifies the time that the driver will wait for a connection to be made with a device. Depending

on network load, the connect time may vary with each connection attempt. The valid range is 1 to 30 seconds.

The default setting is 3 seconds.

Request Timeout

This parameter specifies the time that the driver will wait on a response from the device before giving up and

going on to the next request. Longer timeouts only affect performance if a device is not responding. The valid

range is 100 to 30000 milliseconds. The default setting is 2000 milliseconds.

Retry Attempts

This parameter specifies the number of times that the driver will retry a message before giving up and going on

to the next message. The valid range is 1 to 10. The default setting is 2.

Device IDs

Up to 1024 devices may be defined on a given channel. The device ID is formatted as YYY.YYY.YYY.YYY, where

YYY designates the device's IP address. Each YYY byte should be in the range of 0 to 255. If the device supports

host name resolution, the device ID may also be specified as a standard UNC/DNS name.

Note:

For NetLink users, NetLink communication parameters (such as IP Address, Subnet Mask, and Baud Rate) can be

configured using the NetLink Configuration utility. This application is located in the server's Utilities sub-

directory and can be launched using the Start menu shortcut.

www. kepware.com

1 2 3 4 5 6 7 8 9 10 11 ... 84 85

Sin comentarios

Siemens IP-Module Especificaciones Pagina 6