Siemens IP-Module Especificaciones descargar pdf (Pagina 35)

Siemens TCP/IP Ethernet Driver Help

Note: The device is now configured and can be placed in Run Mode for communications.

How To Configure S7-1500 Connections

The S7-1500 controller has an embedded Ethernet port that supports S7 communications over the Ethernet

protocol. It must be configured to allow access from the server, however. For more information, refer to the

instructions below.

1. To start, open the PLC project in the S7 AI Portal software.

2. Next, open PLC Properties.

3. In the General tab, select Protection. Then, ensure that Full access (no protection) is enabled.

Note: At this time, the Siemens TCP/IP Ethernet Driver does not support the use of a password.

4. Next, check Permit access with PUT/GET communication from remote partner. Then, save the

settings.

www. kepware.com

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 84 85

Sin comentarios

Siemens IP-Module Especificaciones Pagina 35