
Siemens TCP/IP Ethernet Driver Help
Error Descriptions
The following classes of error/warning messages may be generated. Click on the link for a list messages in each
category.
Address Validation Error Messages
Automatic Tag Generation Error Messages
Driver Error Messages
Device Status Error Messages
Error Codes
NetLink Errors
Error
Code
Source Description
0x00 Service could be executed without an error
0x01 Remote
Station
Timeout from remote station
0x02 Remote
Station
Resource unavailable
0x03 Remote
Station
Requested function of master is not activated within the remote station
0x11 Remote
Station
No response of the remote station
0x12 Network Master not into the logical token ring
0x14 Host Resource of the local FDL controller not available or not sufficient
0x15 Host The specified msg.data_cnt parameter is invalid
0x30 Remote
Station
Timeout. The requested message was accepted but no indication was sent back by
the remote station
0x39 Remote
Station
Sequence fault, internal state machine error
0x85 Host Specified offset address out of limits or unknown in the remote station
0x86 Device Wrong PDU coding in the MPI response of the remote station
0x87 Host Specified length to write or to read results in an access outside of limits
Transport Errors
Error Code Description
0x00 Error reason not specified
0x01 Invalid parameter code
0x02 Invalid TPDU type
0x03 Invalid parameter value
Protocol Errors
Note:
Links contain the error codes for the given class.
Error Class Description
0x00 No error
0x81 Error in the application ID of the request
0x82 Error in the object definition (e.g. bad data type)
0x83 No resources available
0x84 Error in the structure of the service request
0x85 Error in the communication equipment
0x87 Access error
0xD2 OVS error
0xD4 Diagnostic error
0xD6 Protection system error
0xD8 BuB error
0xEF Layer 2 specific error
www. kepware.com
63
Comentarios a estos manuales