Siemens SINUMERIK 802D sl Manual de servicio descargar pdf (Pagina 97)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

5.4.7.5 Roughing cycle E

Functionality

The function "Roughing E" allows a single taper contour to be machined, supported by

cycles.

Operating sequences

You can access the turning cycle overview by pressing the softkey "Turning" in the basic

screen for "Manual Machine Plus".

In the softkey menu "Turning", press the softkey "Roughing cycle E".

Alternatively, you can select "Roughing cycle E" from the turning cycle overview with

<Cursor keys> and activate with the input key.

Figure 5-57 Roughing cycle E, position "Outside right"

Input fields

The input fields in the "Roughing E" screen form have the following meanings:

Parameter Description

d1, d2,... The dimensioning type can be selected in this toggle field.

The following options are available:

"d1,d2,l1" -> "d1,l1,angle" -> "d2,l1,angle" -> "d1,d2,angle(d1)" -> "d1,d2,angle(d2)"

The selection is indicated in the diagram displayed on the screen.

Length l1 Enter the length of the taper to be produced, taking the contour start position ("Reference

z0") in the axial axis (Z axis) as the starting point.

Diameter d1 Outside diameter of the taper to be machined in the transverse axis (absolute position of the

X axis in the diameter).

Diameter d2 Inside diameter of the taper to be machined in the transverse axis (absolute position of the

X axis in the diameter).

7XUQLQJ

5RXJKLQJ

F\FOH(

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 129 130

Sin comentarios

Siemens SINUMERIK 802D sl Manual de servicio Pagina 97